Panasonic WH-MDC09C3E5 Servise Manual page 47

B. IF REMOTE CONTROLLER CABLE IS EXPOSED
1. Install the remote controller lower case to the wall with the
two accessory screws (4).
2. Fasten the screws properly until screw head is lower than
the rib and reach the base of remote controller lower case
to ensure they do not damage the PCB inside the remote
controller (1).
3. The feeding-out direction for the remote controller cable
can be either via top, left or right side.
4. Use nipper to cut a notch at the upper case. (Select the
intended feeding-out position)
11.4.3.3. Connecting The Remote Controller Cable To Mono Bloc Unit
Be sure to turn off the main power before installing and connecting
the remote controller. Otherwise, it will cause the electrical shock.
1. Remove the cabinet front plate and cabinet top plate.
2. Connect the remote controller's connector to PCB
CN-REMOTE2 as shown in below illustration. (Refer
wiring diagram for detail.)
3. Guide the remote controller cable through the clamper
and Bushing . (Refer illustration "How to connect
Remote Controller to PCB" for detail.)
4. Reinstall the cabinet front plate and cabinet top plate after
connection complete.
11.4.4. Disposal Of Mono Bloc Unit Drain Water
• If the unit is used in an area where temperature falls below 0°C for 2 or 3 days in succession, it is recommended not to use a
drain elbow, for the drain water freezes and the fan will not rotate.
Install the hose at an angle so that the water smoothly flows out.
5. Route the remote controller cable (2) inside the lower
case in accordance with the intended feeding-out
direction. (Refer to the illustration at below)
6. Insert firmly the connector of remote controller cable (2)
to connector (CON1) in the upper case circuit board.
(Refer to the illustration at below)
7. Secure the remote controller upper case to the lower
case with the tabs provided.
-
How to connect Remote Controller to PCB
47