Panasonic WH-MDC09C3E5 Servise Manual page 46

• Avoid installing the remote controller cable near refrigerant pipes or drain pipes, else it will cause electrical shock or fire.
11.4.3.2. Installing The Remote Controller Unit To The Wall
1. Remove the remote controller (1) lower case.
(Insert a flat-tipped screw driver or similar tool 2 to 3 mm
into one of the gaps at the bottom of the case, and twist to
open. Refer to the illustration at right.)
Be careful not to damage the lower case.
2. Do not remove the protective tape which is affixed to the
upper case circuit board when remove the remote
controller lower case.
3. Secure the lower case to an outlet box or wall. Refer to
(A) or (B) instructions below depending on your choice of
cable installation.
4. Be sure to use only the screws provided.
5. Do not over tighten the screws, as it may result in
damage to the lower case.
A. IF REMOTE CONTROLLER CABLE IS EMBEDDED
1. Embed an outlet box (JIS C 8336) into the wall. Outlet
box may be purchased separately.
Medium-sized square outlet box (obtain locally) Part No.
DS3744 (Panasonic Co., Ltd.) or equivalent.
2. Secure the remote controller lower case to the outlet box
with the two accessory screws (3).
Make sure that the lower case is flat against the wall at
this time, with no bending.
3. Pass the remote controller cable (2) into the box.
4. Route the remote controller cable (2) inside the lower
case through rear feeding-out direction.
5. Insert firmly the connector of remote controller cable (2)
to connector (CON1) in the upper case circuit board.
[Refer to the illustration at below.]
6. Secure the remote controller upper case to the lower
case with the tabs provided.
When the wall is hollow, please be sure to use the sleeve for remote controller cable to prevent dangers caused by mice biting the cable.
46