Specifications - Makita BJN160 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Cd Only for EU countries
Ni-MH
Do not dispose of electric equipment or
Li-ion
battery pack together with household
waste material!
In observance
Directives, on Waste Electric and
Electronic Equipment and Batteries and
Accumulators and Waste Batteries and
Accumulators and their implementation
in accordance with national laws,
electric equipment and batteries and
battery pack(s) that have reached the
end of their life must be collected
separately
environmentally compatible recycling
facility.
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Noise
The typical A-weighted
according to EN60745:
Model BJN160
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Aluminum up to 200 N/mm
Outside edge
Inside edge
-1
)
Overall length
Net weight
Rated voltage
of the
and returned
noise level determined
) : 72 dB (A)
pA
2
1.6 mm / 16 ga
2
1.2 mm / 18 ga
2
2.5 mm / 12 ga
D.C. 14.4 V
END004-6
Model BJN161
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration
European
determined according to EN60745:
Model BJN160
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model BJN161
to an
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENE037-1
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
ENG905-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
2
BJN160
50 mm
45 mm
1,900
313 mm
2.1 kg
) : 73 dB (A)
pA
Wear ear protection
total value
) : 7.0 m/s
h
2
) : 6.5 m/s
h
2
BJN161
1.6 mm / 16 ga
1.2 mm / 18 ga
2.5 mm / 12 ga
50 mm
45 mm
1,900
313 mm
2.2 kg
D.C. 18 V
ENG900-1
(tri-axial vector sum)
2
2
ENG901-1