ENGLISH (Original instructions) SPECIFICATIONS Model BJN160 BJN161 Steel up to 400 N/mm 1.6 mm / 16 ga 1.6 mm / 16 ga Max. cutting capacities Steel up to 600 N/mm 1.2 mm / 18 ga 1.2 mm / 18 ga Aluminum up to 200 N/mm 2.5 mm / 12 ga...
Page 3
Do not expose power tools to rain or wet Power tool use and care conditions. Water entering a power tool will 17. Do not force the power tool. Use the correct increase the risk of electric shock. power tool for your application. The correct Do not abuse the cord.
Page 4
Service If operating time has become excessively 28. Have your power tool serviced by a qualified shorter, stop operating immediately. It may repair person using only identical result in a risk of overheating, possible burns replacement parts. This will ensure that the and even an explosion.
Overloaded: • FUNCTIONAL DESCRIPTION The tool is operated in a manner that causes it to draw an abnormally high current. In this situation, turn the tool off and stop the CAUTION: application that caused the tool to become Always be sure that the tool is switched off and the •...
Page 6
Turn the die holder slightly to make sure that it is Indication lamp with multi function positively locked into position. Tighten the lock nut to secure the die holder. 1. Indicating lamp Permissible cutting thickness 1. Gauge for cutting stainless: 1.2 mm (3/64") 2.
Cutting method 1. Punch 2. Punch holder 3. Screw 4. Hex wrench 5. Loosen 6. Tighten 013274 To install the punch and die, insert the punch into the 013278 punch holder so that the notch in the punch faces Hold the tool so that the cutting head is at a right angle toward the screw.
001145 If you need any assistance for more details regarding Remove and check the carbon brushes regularly. these accessories, ask your local Makita Service Center. Replace when they wear down to the limit mark. Keep • the carbon brushes clean and free to slip in the holders.