Yamaha VMAX VMX17 Owner's Manual page 29

3. Push "SELECT" to
"Stopwatch".
4. Push "RESET".
The multi-function display chang-
es to the Normal mode and the
stopwatch is displayed in place of
the clock.
5. Push "SELECT" to start the stop-
watch.
6. Push the start switch "
LECT" to stop the stopwatch.
7. Push "RESET" to reset the stop-
watch.
TIP
 If neither "SELECT" nor "RESET"
are pushed for one minute, the
screen automatically changes to
the Normal mode.
INSTRUMENT AND CONTROL FUNCTIONS
 Pushing "RESET" for at least two
highlight
seconds changes the screen to
the Normal mode.
 To perform further multi-function
display settings, enter the Select
mode again by pushing and hold-
ing "SELECT" and "RESET" for at
least three seconds.
Using the countdown clock
The countdown clock can be activated
as follows.
1. Push "SELECT"
"Stopwatch".
2. Push "RESET".
3. Push "SELECT"
"Countdown".
" or "SE-
4. Push "RESET". The multi-function
display changes to the Normal
mode, the stopwatch is displayed
in place of the clock, and the
transmission
changes to the countdown clock.
5. Push "SELECT" or shift into gear
to highlight
to highlight
6. Push the start switch " " or "SE-
7. Push "RESET" to reset the count-
8. Repeat steps 5–7, or push "RE-
TIP
gear indicator
To perform further multi-function dis-
play settings, be sure the transmis-
sion is in neutral, then enter the Select
3-14
and the countdown clock starts
counting down from "5". Simulta-
neously, the shift timing indicator
light flashes according to the
number displayed (i.e., when "5" is
displayed, the indicator light flash-
es five times, when "4" is dis-
played, the indicator light flashes
four times, etc.). The stopwatch
starts counting when the count-
down clock finishes counting.
LECT" to stop the countdown
clock.
down clock and stopwatch.
SET" again for at least two sec-
onds to enter the Normal mode.
3