Checking The Engine-Oil Level; Adjusting The Handle Height; Adjusting The Cutting Height - Toro 20337 Operator's Manual

Checking the Engine-Oil Level

Service Interval: Before each use or daily
Note: Max. fill: 0.55 L (18.6 oz), type: SAE 30 detergent
oil with an API service classification of SF, SG, SH, SJ, SL,
or higher.
1. Move the machine to a level surface.
2. Remove the dipstick
1. Dipstick
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube (but do not
screw it in), then remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level is low, slowly pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and repeat
steps 3 through
is correct.
•
If the oil level is high, drain the excess oil until the
oil level on the dipstick is correct; refer to
the Engine Oil (page
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
(Figure 13).
Figure 13
(Figure 13).
5 until the oil level on the dipstick
16).

Adjusting the Handle Height

You can raise or lower the handle in 1 of 2 positions that is
more comfortable for you
1. Loosen both handle knobs until you can push the
square edges of the carriage bolts out of the square
holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height position.
4. Pull the knobs until the square edges of each carriage
bolt fits into its related square hole.
5. Tighten the handle knobs as tight as you can.

Adjusting the Cutting Height

Adjust the cutting height as desired. Set the front wheels to
the same height as the rear wheels
Note: To raise the machine, move the front cutting-height
levers rearward and the rear cutting-height levers forward.
To lower the machine, move the front cutting-height levers
forward and the rear cutting-height levers rearward.
Changing
1. Raise the machine
Note: The cutting-height settings are 25 mm (1 inch); 35
mm (1-3/8 inches); 44 mm (1-3/4 inches); 54 mm (2-1/8
9
(Figure 14).
Figure 14
(Figure 15).
Figure 15
2. Lower the machine
g028376