Stopping The Engine; Recycling The Clippings; Bagging The Clippings - Toro 20337 Operator's Manual

forward to disengage the wheel drive. You can also try
reaching just under the personal pace handle to the metal
handle and push the machine forward a couple of centimeters
(inches). If the machine still does not roll backward easily,
contact an Authorized Service Dealer.

Stopping the Engine

To stop the engine, release the blade-control bar.
Important: When you release the blade-control bar,
both the engine and blade should stop within 3 seconds.
If they do not stop properly, stop using your machine
immediately and contact an Authorized Service Dealer.

Recycling the Clippings

Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the grass bag is on the machine and the bag-on-demand
lever is in the bagging position, move the lever to the recycling
position; refer to Recycling the Clippings (page 11)
recycling the clippings. If the side-discharge chute is on the
machine, remove it; refer to
Chute (page 12) before recycling the clippings.

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer
to Removing the Side-Discharge Chute (page 12)
bagging the clippings. If the bag-on-demand lever is in the
recycling position, move it to the bagging position; refer to
Operating the Bag-on-Demand Lever (page
before
Removing the Side-Discharge
before
12).
Installing the Grass Bag
1. Raise and hold up the rear deflector
2. Install the grass bag, ensuring that the pins on the bag
rest in the notches on the handle
1. Notch (2)
2. Rear deflector
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps above.
11
(Figure 11).
(Figure 19).
Figure 19
3. Grass bag pin (2)