Setup; Assembling And Unfolding The Handle - Toro 20337 Operator's Manual

131-0894
Traction Adjustment
1. Attention; read the Operator's Manual—1) Loosen the
knob by turning it counter clockwise; 2) Pull the cable(s)
away from the engine to decrease the traction, or push
the cable(s) toward the engine to increase the traction; 3)
Tighten the knob by turning it clockwise.
131–4514
1. Warning—read the Operator's Manual.
2. Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts; keep all guards and
shields in place.
3. Cutting/dismemberment hazard of hand or foot, mower
blade—disconnect the spark-plug wire and read the
instructions before servicing or performing maintenance.
4. Thrown object hazard—keep bystanders a safe distance
from the machine; stop the engine before leaving the
operating position; pick up any debris before mowing.
5. Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; look behind you when backing up.

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
1. Handle knob
2. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end
1. Pin
4
(Figure 3).
Figure 3
2. Carriage bolt
(Figure 4).
Figure 4
2. Handle end