Installing The Recoil-Starter Rope In The Rope Guide; Filling The Engine With Oil - Toro 20337 Operator's Manual

Note: The pins will not show through the holes in the
handle ends when the handle is in the folded position.
3. Unfold the handle to the operating position by rotating
it rearward (Figure 5).
Figure 5
1. Folded position
4. Insert the carriage bolt (with the bolt head toward
the inside) through the upper or lower square hole in
handle bracket and the upper hole in the handle end
(Figure 6).
Figure 6
1. Handle knob
5. Loosely install the handle knobs onto the carriage bolts.
6. Refer to steps 3 through 5 of
Height (page 9).
2. Operating position
2. Carriage bolt
Adjusting the Handle
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 7).
1. Recoil-starter rope
3

Filling the Engine with Oil

No Parts Required
Procedure
Important: Your machine does not come with oil in
the engine, but it does come with a bottle of oil. Before
starting the engine, fill the engine with oil.
Max. fill: 0.55 L (18.6 oz), type: SAE 30 detergent oil with an
API service classification of SF, SG, SH, SJ, SL, or higher.
Note: When the crankcase is empty, pour about 3/4 of
the crankcase capacity of oil in the crankcase, then do the
following:
1. Move the machine to a level surface.
2. Remove the dipstick by rotating the cap
counterclockwise and pulling it out
5
Figure 7
2. Rope guide
(Figure 8).