Assembling The Grass Bag - Toro 20337 Operator's Manual

Figure 8
1. Dipstick
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick into the oil-fill tube (but do not
screw it in), then remove the dipstick.
5. Read the oil level on the dipstick
•
If the oil level is low, slowly pour a small amount of
oil into the oil-fill tube, wait 3 minutes, and repeat
steps 3 through 5
is correct.
•
If the oil level is high, drain the excess oil until the
oil level on the dipstick is correct; refer to
the Engine Oil (page
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page
(Figure 8).
until the oil level on the dipstick
Changing
16).
16).
4

Assembling the Grass Bag

No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
1
2
1. Handle
2. Frame
Note: Do not slip the bag over the handle
2. Hook the bottom channel of the bag onto the bottom
of the frame (Figure
6
g027257
3
Figure 9
3. Grass bag
(Figure
10).
Figure 9.
9).