Bagging The Clippings; Installing The Grass Bag - Toro 20995 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before bagging the clippings.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.

Installing the Grass Bag

1. Remove the mulch plug (Figure 29).
2. Route the starter rope around the lower rope guide
(Figure 30).
Note: The lower rope guide releases the starter rope
when you pull the recoil start handle.
3. Insert the grass bag handle into the grooves at the
top of the mower (Figure 31).
Figure 29
Figure 30
Important: The mower has a safety switch that
prevents you from starting the mower unless you
first install the grass bag securely on the mower.
Removing the Grass Bag
1. Route the starter rope around the lower rope guide
(Figure 32).
2. Lift the grass bag handle out from the grooves at
the top of the mower and remove the bag from the
mower (Figure 33).
3. Insert the mulch plug (Figure 34.
13
Figure 31
Figure 32
Figure 33