Figure 44; Lubricating The Wheel Gears; Lubricating The Upper Handle - Toro 20995 Operator's Manual

Figure 44

5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.

Lubricating the Wheel Gears

Service Interval: Yearly
1. Remove the wheel bolt in the center of each rear
wheel and remove the rear wheels.
2. Apply a lubricating oil to the inner and outer sides
of the gear as shown in Figure 45.
Figure 45
3. Install the rear wheels.

Lubricating the Upper Handle

Service Interval: Yearly
Model 20996 only
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant yearly or as
needed.
1. Spray the outer plastic end of the inner handle
(Figure 46).
Note: Use the straw that comes with the spray can
to direct the spray.
2. Push the upper handle fully down and spray the
inner plastic surface of the outer handle (Figure 47).
Adjusting the Self-propel Drive
Cable
Model 20995 only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1. Loosen the cable support nut (Figure 48).
18
Figure 46
Figure 47