Installing The Roll Over Protection System - Toro Z MASTER Z500 series Setup Instructions

Figure 3
3. Remove the wheel nuts from both sides of the
vehicle and remove the right angle retaining
plate (Figure 4). Discard the screws and
retaining plate.
Figure 4
4. Mount the wheels with the valve stem to the
outside and secure them with the wheel nuts
previously removed (Figure 5).
Figure 5
5. Torque the wheel nuts to 95 ft-lb (128 N·m).
6. Remove the jack-stands.
Step
4
Installing the Roll Over
Protection System
Parts needed for this step:
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt, (3/8 x 1 inch)
8 Curved washer
8 Flange nut, (3/8 inch)
2 Bolt, (1/2 x 3–1/4 inch)
2 Flange nut, (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section
to the frame, with 8 bolts (3/8 x 1 inch), 8
curved washers, and 8 flange nuts (3/8 inch)
(Figure 6).
Note: The curve washer cone must be
installed toward the bolt head.
Figure 6
2. Install the lanyard clips onto the long bolts
(1/2 x 3-1/4 inch) (Figure 7).
Note: Make sure the bent tab points toward
the head of the bolt.
3