Installing The Roll Over Protection System - Toro 74253 Setup Instructions

Figure 4
4. Mount the wheels with the valve stem to the
outside and secure them with the wheel nuts
previously removed.
5. Torque the wheel nuts to 95 ft-lb (128 N·m).
6. Remove the jack-stands.
Figure 5
Step
4
Installing the Roll Over
Protection System
Parts needed for this step:
1 Roll bar, right section
1
Roll bar, left section
1 Roll bar, center section
8
Bolt, (3/8 x 1 inch)
8 Curved washer
8
Flange nut, (3/8 inch)
2 Bolt, (1/2 x 3–1/4 inch)
2
Flange nut, (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section
to the frame, with 8 bolts (3/8 x 1 inch), 8
curved washers, and 8 flange nuts (3/8 inch).
Note: The curve washer cone must be
installed toward the bolt head.
Figure 6
2. Install the lanyard clips onto the long bolts
(1/2 x 3-1/4 inch).
Note: Make sure the bent tab points toward
the head of the bolt.
Figure 7
3. Lightly oil the ends of the center roll bar
section.
4. Loosely install the center roll bar section using
2 bolts (1/2 x 3-1/4 inch) and 2 flange nuts
(1/2 inch).
Note: Make sure the bolts are installed from
the outside of the roll bar.
Note: Make sure the lanyard tab is installed
as show and points forward.
3