Installing The Motion Control Levers - Toro Z MASTER Z500 series Setup Instructions

Figure 11
Step
5
Installing the Motion
Control Levers
Parts needed for this step:
1
Control lever, right
1 Control lever, left
4
Bolt (3/8 x 1 inch) (2 assembled)
4 Curved washer (3/8 inch) (2 assembled)
Procedure
1. Rotate the handles to the upright position
(Figure 12).
Figure 12
2. Loosely install the levers on the outside, using
4 bolts and curved washers (Figure 12).
Note: Install the levers in the top and middle
holes for the high position or the middle and
bottom holes for the low position, as desired.
3. In the neutral position, raise the levers, bringing
them together, and slide them until they are
aligned, then tighten the bolts (Figure 13).
Figure 13
5