Table of Contents
Advertisement
How the hob is operated
The glass ceramic hob is equipped with
electronic sensor controls which react
to finger contact. For safety reasons, in
order to switch the hob on, the On/
Off sensor needs to be touched for a
little longer than the other sensors.
A tone sounds each time a sensor is
touched.
When the hob is switched off, only the
symbols for the On/Off , Safety
lock , Stop&Go and number sen‐
sors are visible. When the hob is
switched on all the other sensors light
up as well.
In order to set or alter a power level or
the time, the cooking zones and the
timer must be "active". To activate a
cooking zone or the timer, touch the
sensor for selecting the relevant cook‐
ing zone or timer. The relevant cooking
zone or timer display will begin to flash
when touched.
Exception: If only one of the cooking
zones is in operation, you can alter the
power level without activating the cook‐
ing zone.
Malfunction due to dirty and/or cov‐
ered sensors
If the sensors are dirty or covered
this could cause them to fail to react,
to activate a function or even to
switch the hob off automatically (see
"Safety switch-off"). Placing hot
pans on the sensors/indicators can
damage the electronic unit under‐
neath.
Keep the sensors and indicators
clean and do not place anything on
top of them. Do not place hot pans
on them.
Operation
25
Advertisement
Table of Contents
