Table of Contents
Advertisement
abnormally, stop immediately. Turn engine off,
wait for all motion to stop and inspect for
damage.
26. Before getting off the seat:
A. Move traction pedal to neutral.
B. Set the parking brake.
C. Disengage the cutting units and wait for the
blades to stop spinning.
D. Stop the engine and remove key from the
ignition switch.
27. Whenever machine is left unattended, make
sure, key is removed from ignition switch and
parking brake is set.
Maintenance
28. Before servicing or making adjustments to the
machine, stop the engine and remove key from
switch to prevent accidental starting of the
engine.
29. Check performance of all interlock switches
daily. Do not defeat interlock system. It is for
your protection. 30. To ensure entire machine is
in good operating condition, frequently check
and keep all nuts, bolts, screws and hydraulic
fittings tight.
31. Make sure all hydraulic line connectors are
tight, and all hydraulic hoses and lines are in
good condition before applying pressure to the
system.
32. Keep body and hands away from pin hole leaks
or nozzles that eject hydraulic fluid under high
pressure. Use paper or cardboard, not hands, to
search for leaks. Hydraulic fluid escaping under
pressure can have sufficient force to penetrate
skin and do serious damage. If fluid is injected
into the skin it must be surgically removed
within a few hours by a doctor familiar with
this form of injury or gangrene may result. 33.
Before disconnecting or performing any work
on the hydraulic system, all pressure in system
must be relieved by stopping engine and
lowering cutting units to the ground.
Safety
34. If major repairs are ever needed or if assistance
is desired, contact an Authorized Toro
Distributor.
35. To reduce potential fire hazard, keep the engine
area free of excessive grease, grass, leaves and
accumulation of dirt.
36. If the engine must be running to perform a
maintenance adjustment, keep hands, feet,
clothing, and any other parts of the body away
from the cutting units and any moving parts.
Keep everyone away.
37. Do not overspeed the engine by changing
governor settings. To assure safety and
accuracy, have an Authorized Toro Distributor
check maximum engine speed with a
tachometer.
38. Engine must be shut off before checking oil or
adding oil to the crankcase.
39. To insure optimum performance and safety, use
genuine TORO replacement parts and
accessories. Replacement parts and accessories
made by other manufacturers could be
dangerous, and such use could void the product
warranty of The Toro Company.
– 5 –
Advertisement
Table of Contents
