Barco DATA 708HS R9002230 Owner's Manual page 6

Safety Instructions
CAUTION fire hazard
WARNING: Do NOT Place Flammable or Combustible
Materials Near Projector !
BARCO large screen projection products are designed and manufactured to
meet the most stringent safety regulations. This projector radiates heat on its
external surfaces and from ventilation ducts during normal operation, which is
both normal and safe.
Exposing flammable or combustible materials into close proximity of this
projector could result in the spontaneous ignition of that material, resulting in
a fire. For this reason, it is absolutely necessary to leave an “exclusion zone”
around all external surfaces of the projector whereby no flammable or
combustible materials are present. The exclusion zone must be not less than
10 cm (4”) for BARCO Retro Projectors and not less than 40 cm (16”) for all
other BARCO projectors. Do not cover the projector with any material while
the projector is in operation.
Keep flammable and combustible materials away from the projector at all
times. Mount the projector in a well ventilated area away from sources of
ignition and out of direct sun light. Never expose the projector to rain or
excessive moisture. In the event of fire, use sand, , or dry powder fire
CO 2
extinguishers; never use water on an electrical fire.
Always have service performed on this projector by authorized BARCO service
personnel. Always insist on genuine BARCO replacement parts. Never use
non-BARCO replacement parts as they may degrade the safety of this
projector.
This product complies to standards set by Underwriter’s Laboratories, Inc., Canadian
Standards Association, and meets all applicable U.S. / Canadian and European government
regulations or directives.