Setting amount of rinse aid
The amount of rinse aid can be set from
. Please set rinse aid on
to obtain very good drying results
is already set in factory).
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button `
until : ... is indicated on the digital
4. Release both buttons.
The LED for button # flashes
and the digital display h displays
the factory setting :
5. Press programme button # until
the factory set value :
is indicated on the digital
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
2. Press START button `.
The set value is saved.
3. Close the door.
Downloaded from DishWasher-Manual.com Manuals
Switching off rinse aid refill
If the rinse-aid refill indicator H is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse aid" and set the
The rinse aid refill indicator H is now
U t e n s i
Cutlery and utensils made of wood.
Delicate decorative glasses, craft
and antique utensils. These decors
are not dishwasher-proof.
Plastic parts not resistant to heat.
Copper and tin utensils.
Utensils which are soiled with ash,
wax, lubricating grease or ink.
Aluminium and silver parts have a
tendency to discolour and fade during
the wash cycle. Even some types of
glass (e.g. crystal glass objects) may
turn cloudy after many wash cycles.