Replacing The Angled Connector - Miele CVA 6800 Operating And Installation Instructions

Problem solving guide
Replacing the angled
connector
If, instead of being frothed, the milk is
only being heated up, check the
following first:
– Is the milk in the milk flask cold
(< 10 °C)?
– Have the central spout and the milk
flask lid been cleaned carefully?
– Is the central spout correctly fitted?
If after checking the above, milk still
cannot be frothed, replace the angled
connector as follows.
You will need the replacement angled
connector supplied with the coffee
machine.
Do not use a needle or similar
implement. This would damage the
components.
 Open the service flap on the back of
the appliance door.
88
 First pull the air intake tube  out of
the opening . Then pull off the
elbow connector .
 Pull both tubes out of the elbow
connector.
 Clean the air intake tube  under
running water with the cleaning brush
supplied. "Blowing through" can help
to dislodge blockages.
 Insert the brush in the milk tube .
Move the brush back and forth as far
as possible until all milk residues
have been removed.
 Take the new angled connector (You
can dispose of the old angled
connector with normal household
waste).