Servicing The Cutting Blades - Toro 30317 Operator's Manual

3
1
1
3
Figure 43
1. Hose clamp
2. Fuel line

Servicing the Cutting Blades

To ensure a superior quality of cut, keep the blades sharp.
For convenient sharpening and replacement, you may want
to keep extra blades on hand.
Warning
A worn or damaged blade can break, and a piece
of the blade could be thrown into the operator's or
bystander's area, resulting in serious personal
injury or death.
Inspect the blade periodically for wear or
damage.
Replace a worn or damaged blade.
Before Inspecting or Servicing the Blades
Park the machine on a level surface, disengage the blade
control bail and set the parking brake. Turn the ignition key
to off. Remove the key and disconnect the spark plug
wire(s) from the spark plug(s).
Inspecting the Blades
1. Inspect the cutting edges (Fig 44). If the edges are not
sharp or have nicks, remove and sharpen the blades.
Refer to Sharpening the Blades on page 35.
2. Inspect the blades, especially the curved area (Fig. 44).
If you notice any damage, wear, or a slot forming in this
area (item 3 in Fig. 44), immediately install a new
blade.
2
m–5234
3. Filter
34
Figure 44
1. Cutting Edge
2. Curved Area
Checking for Bent Blades
1. Rotate the blades until the ends face forward and
backward (Fig. 45). Measure from a level surface to the
cutting edge, position A, of the blades (Fig. 46). Note
this dimension.
Front
A
Figure 45
MEASURE FROM
CUTTING EDGE TO A
LEVEL SURFACE
Figure 46
2. Rotate the opposite ends of the blades forward.
3. Measure from a level surface to the cutting edge of the
blades at the same position as in step 1. The difference
between the dimensions obtained in steps 1 and 2 must
not exceed 1/8 inch (3 mm). If this dimension exceeds
1
2
3
m–151
3. Wear/slot Forming
A
m–1078
m–1087