Checking Front Wheel Toe-In; Checking Tire Pressure; Activating The Battery - Toro 73570 Setup Instructions

Set-Up Instructions
Check to Insure that the
Steering Linkage is Centered
1. With the tractor on a level surface, turn the
steering wheel fully to the left and check the
clearance of the left hand spindle stop to the stop
on the front axle. There should be a slight
clearance between the stops (Fig. 9).
1
Front of Tractor
Figure 9
1. Left hand spindle stop
2. Axle stop
2. Repeat for the right front tire in a right turn.
3. If the stops on one side hit, and on the other side
have clearance, shorten the tie rod on the side
that hits, and equally lengthen the tie rod on the
opposite side until both sides have clearance.
Recheck the toe in.
6
3
2
m–4265
3. Clearance
Checking Front Wheel Toe–In
With the tractor on a level surface, check to make
sure the front wheel toe-in is between 1/8" and 1/4".
For instructions on adjusting toe-in, refer to the
Maintenance section in Operator's Manual.

Checking Tire Pressure

Check front and rear tire pressure. The correct front
and rear tire pressure is 20 psi (138 kPa).

Activating the Battery

POTENTIAL HAZARD
Battery electrolyte contains sulfuric acid
which is a deadly poison and it causes
severe burns.
WHAT CAN HAPPEN
If you carelessly drink electrolyte you could
die or if it gets onto your skin you will be
burned.
HOW TO AVOID THE HAZARD
Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
Fill the battery where clean water is always
available for flushing the skin.
Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the tractor (refer to
Removing the Battery in your tractor Operator's
Manual).
Note: Never fill the battery electrolyte with
the battery installed in the tractor.