Installing The Rear Wheels; Installing The Front Wheels - Toro 73570 Setup Instructions

Set-Up Instructions
DESCRIPTION
Bolt – 1/4"-20 x .88" Long
Hex Nut – 1/4"-20
Flat washer, 1/4"
Grille Screw – #8 x .50" Long
Grille Washer – .75" O.D.
Hitch Pin
Hairpin Cotter
Flat Washer – .50" I.D.
Key
Operator's Manual
Engine Operator's Manual

Installing the Rear Wheels

1. Remove the four wheel bolts holding the rear
shipping brackets to the rear hubs.
2. Using a jack or suitable hoist, raise the rear of
the tractor only high enough to install the rear
wheels.
3. Install the wheels onto the hubs with the valve
stems facing inward (Fig. 1).
4. Tighten the wheel bolts to 75–80 ft-lb
(105–112 N m).
1
Figure 1
1. Hub
2. Rear wheel
2
2
3
m–1278
3. Wheel bolt (5)
QTY.
2
2 Attaching the battery cables
2
2
Securing the grille
2
1
1 Installing the drawbar hitch pin
2
2 Use in ignition and "Key Choice" switches
1
Read before operating the tractor
1

Installing the Front Wheels

IMPORTANT: Never raise the front of the
tractor by placing a jack under the bumper
or front axle because the tractor may be
damaged.
1. The front hood support braces have two slots
(Fig. 2) that may be used to lift the tractor to
install the front wheel spindles. To access these
slots, remove the front grille and raise the hood.
2
1
1. Slots
USE
2
Figure 2
2. Grille Grommets
1
m–3454