Toro 73570 Setup Instructions page 4

Set-Up Instructions
11. Secure the wheel to the spindle with a cotter pin.
Bend the ends of the cotter pin completely
around the spindle.
12. Install a hubcap onto the hubcap washer until it
snaps in place (Fig. 4).
13. Look at the end of the steering arm and the
inside edge of the tire. The end of the steering
arm and the inside edge of the tire must be
parallel (Fig. 5). Adjust the steering arm if
required.
1
Figure 5
1. Wheel
2. Steering arm
14. Insert a spindle cap into the steering arm
(Fig. 4).
15. Repeat the procedure on the opposite end of the
front axle.
16. Lubricate both spindles and the front axle pivot
until grease begins to come out of the bearings.
17. After servicing the battery, replace the front
grille of the tractor and secure the grille with two
#8 x .50" long grille screws and .75" O.D. grille
washers in the upper two grille mounting holes
(Fig. 6).
4
2
3
m–3451
3. Parallel relationship
1
Figure 6
1. Grille screw (1 of 2)
2
m–3558
2. Grille washer (1 of 2)