Installing The Seat; Installing The Steering Wheel; Checking Front Wheel Toe-In - Toro 73547 Setup Instructions

Set-Up Instructions

Installing the Seat

1. Mount the seat to the seat base using two 5/16"
shoulder bolts and lock nuts (Fig. 1).
2. Insert the seat switch wire through the center
opening in the seat base (Fig 1).
3. Push the seat switch wire connector into the wire
harness connector.
1
2
6
Figure 1
1. Seat
2. Seat base
3. 5/16" shoulder bolt (2)
4. 5/16" Locknut (4)

Installing the Steering Wheel

1. Install the boot washer onto the steering shaft
(Fig. 2).
2. Remove the plastic trim cover from the steering
wheel (Fig. 2)
2
3
5
4
m–3453
5. Seat switch wire
connector
6. Opening for seat switch
wire
3. Install the steering wheel onto the shaft,
carefully aligning the splines (Fig. 2).
Note: There is no fixed straight ahead
position on power steering models.
4. Secure the steering wheel to the shaft with a lock
washer and nut (Fig. 2). Tighten the retaining nut
to 45–50 ft–lbs.
5. Install the trim cover on the steering wheel.
6
3
1
2
Figure 2
1. Boot washer
2. Steering shaft
3. Steering wheel
Checking Front Wheel Toe–In
With the tractor on a level surface, check to make
sure the front wheel toe-in is between 1/8" and 1/4".
For instructions on adjusting toe-in, refer to the
Maintenance section in Operator's Manual.
5
4
m–2482
4. Lock washer
5. Nut
6. Trim cover