Electrical System
Maintenance
Servicing the Headlights
Removing the Bulb
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood.
6. Disconnect the wire connectors from both of the
bulb holder terminals.
7. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Figure 30).
Figure 30
1. Bulb holder
2. Reflector
3. Tab (2)
8. Push and rotate the bulb counterclockwise about
1/4 turn until it stops and remove the bulb from the
bulb holder (Figure 31).
4. Slots
5. Terminals
1. Bulb
2. Metal pins
Installing the Bulb
1. Align the metal pins on the base of the bulb with the
slots in the bulb holder and insert the base into the
holder (Figure 31).
2. Push and rotate the bulb clockwise until it stops.
3. Align the tabs on the bulb holder (Figure 31) with
the slots in the reflector.
4. Insert the bulb holder into the reflector and rotate it
1/4 turn clockwise until it stops.
5. Connect the wire connectors to the terminals on the
bulb holder.
Replacing the Fuse
The electrical system is protected by fuses. They are
located beneath the hood, near the fuel tank (Figure 32).
If a fuse goes out, check the circuit wiring for a short.
1. Main/battery
2. Interlock, electric clutch,
and cruise control
27
Figure 31
3. Bulb holder
4. Slots
Figure 32
3. Full bag buzzer
4. Extra fuse