Table of Contents
Advertisement
2. Position the blades 90 degrees to each other
(Figure 41).
3. Tighten the blade bolts to 37 ft-lb (50 N-m).
Removing the Mower
1. Park the machine on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to stop.
5. Remove the ignition key.
6. Disconnect the wire from the spark plug.
7. Move the height-of-cut lever to the lowest position.
8. Pull the idler arm assembly in and remove the V-belt
from the pulley (Figure 42).
Figure 41
1. Idler pulley and idler arm
assembly
2. V-belt
3. Engagement spring
4. Rear hairpin clips
5. Rear pins
6. Front hairpin clips
Note: The bag-on-demand assembly is not shown
for the purpose of clarity.
9. Disconnect the spring from the engagement lever
(Figure 42).
10. Release the mower from the tunnel by lifting the
tunnel off the 2 welded pins and pulling the tunnel
rearward approximately 4 inches (10 cm). Secure the
tunnel to prevent it from falling down.
11. Remove the hairpin clips from the 2 rear pins and
remove the pins (Figure 42).
Note: You may need a pliers to pull out the second
pin.
12. Remove the hairpin clip from the front pin and
remove the pin (Figure 42).
13. Remove the V-belt from the engine pulley
(Figure 42).
14. Slide the mower out from beneath the machine.
33
Figure 42
7. Front pin
8. Engine pulley
9. V-belt pulley
10. Front suspension M12
nuts
11. Bag-on-demand assembly
(not shown)
Advertisement
Table of Contents
