Servicing The Grass Collector; Removing The Grass Collector; Installing The Grass Collector; Cleaning The Grass Collector And Tunnel - Toro 74593 Operator's Manual

Servicing the Grass
Collector

Removing the Grass Collector

1. Use 2 hands to tip the grass collector forward
(Figure 37).
Figure 37
2. Carefully slide the assembly rearward off the support
brackets.

Installing the Grass Collector

1. Lift the grass collector assembly with 2 hands.
2. Tip the collector forward approximately 40 degrees
and slide it onto the 2 support brackets at the rear of
the machine (Figure 37).
Note: Ensure that the arrow on the top of the grass
collector aligns with the arrow on the machine. The
mower will not function when the grass collector is not
in place.
Cleaning the Grass Collector
and Tunnel
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Remove the grass collector; refer to Removing the
Grass Collector.
6. Clean the collector bag with pressurized water.
7. Wipe the area around the full-bag sensor.
8. Ensure that the bag on demand is in the bagging
mode and clean the inside of the tunnel all the way
to the mower.
9. Install the grass collector; refer to Installing the
Grass Collector.
Note: Allow the bag to dry thoroughly before
installing it.
31