Setup; Installing The Handle - Toro 04018 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
1
Handle
Kickstand assembly
Spring
Small spacer
Large spacer
2
Large bolt (M8–1.25 x 100)
Small bolt (M8–1.25 x 030)
Locknut (M8 x 1.25)
Washer (M8)
3
No parts required
4 Transport wheels (Optional
Transport Wheel Kit, Model 04123)
5
No parts required
6
Grass basket
Operator's Manual
Engine Operator's Manual
7
Parts Catalog
Operator Video
Certicate of compliance
Note: Determine the left and right sides of the
machine from the normal operating position.
Step
1

Installing the Handle

Parts needed for this step:
1
Handle
Procedure
1. Remove the flange lock nut from the bolt and
pivot pin on each side of the mower (Figure 4).
Description
1. Flange lock nut
2. Insert the handle ends through the slots in the
10
Qty.
1 Install the handle.
1
1
1
1
Install the kickstand for Flex 18
Mowers Only.
1
1
2
2
–
Adjust the handle.
2 Install the transport wheels.
Check the engine oil and
–
transmission uid levels
1 Install the grass basket.
1
1
Read the manuals and watch
1 the video before operating the
machine.
1
1
Figure 4
2. Pivot pin
handle support arms (Figure 5).
Use