Recycling The Clippings; Bagging The Clippings; Installing The Grass Bag - Toro 20835 Operator's Manual

Recycling the Clippings

Model 20836 only
Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the mower while
you are recycling the clippings.
1. Stop the engine and wait for all moving parts to stop.
2. Press the button on top of the Recycling/bagging
lever and move the lever to the recycling mode
(model 20836 only) (Figure 16).
1. Recycling mode
Figure 16
2. Bagging mode

Bagging the Clippings

Use the grass bag to collect grass and leaf clippings from
the lawn.
WARNING
A worn grass bag could allow small stones and
other similar debris to be thrown in the operator's or
bystander's direction and result in serious personal
injury or death to the operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
1. Stop the engine and wait for all moving parts to stop.
2. To bag the grass clippings, install the grass bag (refer
to Installing the Grass Bag). Press the button on top
of the Recycling/bagging lever and move the lever to
the bagging mode (model 20836 only) (Figure 16).

Installing the Grass Bag

1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door, install the bag in the
notches, and lower the rear door (Figure 17).
10
Figure 17