Product may vary slightly from what is illustrated.
3 mil 5 mil
Black & Decker Flash Series laminators provide a series of audible alerts to aid its
Black & Decker Flash Series laminators feature an auto-shutoff mechanism that will
automatically power down the laminator after 60 minutes. This feature is an added
convenience in the event that the laminator is left on while not in use.
• If the laminator powers down during lamination, press the power button
and select the appropriate temperature mode.
• You may continue laminating once the light on the selected mode button is
steadily lit and the 3 beep audible alert sounds.
Black & Decker Flash Series laminators include an integrated corner punch to round
the corners of a trimmed, laminated item for a more professional appearance.
NOTE: Corner punch chips are captured in a small drawer located on the rear of the
laminator (Fig. C). Periodically empty this drawer by removing it from the unit and
emptying its contents into a waste basket.
After the thermal/cold mode is selected and the laminator is
ready for use
Every 10 minutes to notify that the unit is powered on
NOTE: Always power down and unplug the laminator when
not in use.
1. Insert the squared
corner of laminated
item into corner punch
slot and press down
on punch button.
Corner punch chip drawer
Out-feed table (LAM95FH,
Power cord wrap
Power on/off switch
Reverse Lever (LAM95)
Reverse mode select
5 mil pouch select
3 mil pouch select
Cold mode pouch select
2. Remove laminated
item from punch slot
and repeat step 1 for