Performing A Synchronization (Sync) - Sennheiser EK 6042 Instruction Manual

Using the EK 6042
Main
Submenu
menu
Level AUX 1
Level AUX 2
Test tone
PHONES Volume
PHONES Listen to
Store Scene
Network
Info
Licence List
Spectrum Scan

Performing a synchronization (Sync)

Suitable settings for the transmitter must have been made in the
Transmitter, Frequency and Squelch submenus in the CH1 Settings or
CH2 Settings menu.
There are two options to start a synchronization.
Option one:
Long-press the
The receiving channel selection appears.
Select the receiving channel (CH1 or CH2)
with which the transmitter is to be synchro-
nized and press the
synchronization.
Option two:
Call up the Sync submenu (in the CH1 Settings or CH2 Settings menu)
and use the
By selecting either CH1 Settings or CH2 Settings, you already prese-
lect the receiving channel with which the transmitter is to be synchro-
nized. This is why the receiving channel selection does not appear.
Once the synchronization has been started,
Hold to IR appears on the display panel and
the infra-red interface flashes blue.
Possible settings
Adjusts the audio level
on or off
Adjusts the headphone volume
Routes the signal of the receiving channel CH1
or CH2 or CH1+CH2 to the headphone output
Stores the current settings as a scene
Changes the IP address of the receiver
Displays the firmware version and the word
clock status
Displays licensed frequencies
Performs a frequency scan
button.
button to start the
button to start the synchronization.
EK 6042 | 17