7.17. Remove the SS-Board
1. Unlock the cable clampers to free the cable.
2. Disconnect the connectors (SS11, SS12, SS33 and
SS35).
3. Remove a short-jumper connector SS34 and re-use for
new SS-Board.
4. Disconnect the flexible cables (SS61, SS63, SS64 and
SS66).
5. Remove the screws (×6
7.18. Remove the Stand brackets
1. Remove the Plasma panel section from the servicing
stand and lay on a fiat surface such as a table (covered)
with the Plasma panel surface facing downward.
2. Remove the Stand brackets (L, R) fastening screws (×5
each) and remove the Stand brackets (L, R).
) and remove the SS-Board.
7.19. Remove the D-Board
1. Remove the A-Board unit. (See section 7.8.)
2. Disconnect the connectors (D3, D5 and D25).
3. Disconnect the flexible cables (D20, D31, D32 and D33).
4. Remove the screws (×4
7.20. Remove the C1-Board
1. Remove the A-Board unit. (See section 7.8.)
2. Remove the Side control unit assy. (See section 7.10.)
3. Remove the Stand bracket L. (See section 7.18.)
4. Remove the DD-Heat-sink fastening screws (×12
5. Remove the DD-Heat-sink (×6).
6. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5 and CB6).
7. Disconnect the flexible cables (C10 and C11).
8. Remove the screws (×5
22
) and remove the D-Board.
).
) and remove the C1-Board.