Jp14 Clear Cmos; Connecting Serial Ata Disk - AOpen AX4B-533 Plus Easy Installation Manual

Everything you need to boot this
motherboard is included in this
Easy Installation Guide. For more
information, a complete
User's Manual can be found in the
Bonus Pack CD. Thanks for the
help of saving our earth.
Motherboard x1
This Easy Installation Guide x1
User Manual x 1
80-wire IDE Cable x2
Floppy Disk Drive Cable x1
S/PDIF Cable x1 (User Upgrade Optional)
Serial ATA Cable x1
Bonus Pack CD x1
Retention Module x1
PART NO: 49.8AG10.E01 DOC. NO: AX4B533P-EG-E0207A
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
Online
5. Connect ATX power cable back to connector PWR2.
To connect a Serial ATA disk, you have to have a 7-pin serial ATA cable. Connect two ends of the serial ATA
cable to the serial ATA header on the mainboard and the disk. Like every other traditional disk, you also have
to connect a power cable. Please note that it is a jumper free implement; you don't need to set jumpers to
define a master or slave disk. When connecting two serial ATA disks, the system will automatically take the
one connected to "Serial ATA 1" header as a master disk.

1. JP14 Clear CMOS

Pin 1
1 1
Clear CMOS
Normal
(default)

2. Connecting Serial ATA Disk

Tip: When should I Clear CMOS?
1. Boot fail because of overclocking...
2. Forget password...
3. Troubleshooting...