Treatment; How To Treat - Remington IPL6250 Manual

3 Press the Flash Button to deliver a flash.
• Mild to moderate discomfort is normal. If a flash delivered at Energy Level 1 feels tolerable, increase to
Energy Level 2. Move the device to a different spot and flash the i-LIGHT one more time. Repeat this
process until you find the setting that feels right for you.
• Wait 24 hours and then look at the test area. If the skin appears normal, proceed with your first full
treatment at the energy level you determined is right for you.
, NOTE: You must test the device on each area of the body you wish to treat.

TREATMENT

C
• Multi-Flash Mode: The i-LIGHT device will flash when the Flash Button is pressed and will continue to
flash every 3 seconds when the skin contact sensors are fully engaged. The Multi-Flash mode allows
you to quickly treat large areas by simply gliding the hand piece over the skin after each flash.

, How to treat:

• Place the Flash Window firmly against the skin - ensure the Skin Contact Sensors are fully engaged.
, NOTE: When the Skin Contact Sensors are fully engaged you will hear a 'chirp' and the Bulb Status
Indicator Display will illuminate green.
2 Press the flash button to deliver a flash. You should expect to see a bright flash of light (similar to a
camera flash), and you should feel a mild sensation of warmth.
3 Move to the next area and treat in a grid like pattern to ensure full coverage of the treatment area.
• For Single-Flash Mode, press the Flash Button each time you move to the next area.
• For Multi-Flash Mode, keep your finger on the Flash Button to keep it depressed and glide to the next
area being sure to keep the Skin Contact Sensors fully engaged. The next flash will be delivered
automatically after 3 seconds.
, NOTE: During Multi-Flash Mode if you let go of the Flash Button or lose skin contact, simply resume
treatment by repeating the above steps.
12
Fig. 7