Hitachi NR 83A Instruction Manual And Safety Instructions page 12

English
(3) Press the stop lever and slide the nail feeder forward until
it contacts the nail strip.
Nall Feeder Stop Lever
J~
\J
IF~1 = =-f-
*~~ ~ ~\\~\\~Jci\
'~~
NOTE:
O USe nail strip at least 5 nails remaining.
~!7
r'~~~;
O Set heads of nails overlapped as shown in the below
figure.
O Ensure that the head of tail nai[ is set under the nail
stopper of nail feeder.
Tail Nail Nail Stopper
o
x
NAILER OPERATION
Read section titled "SAFETY"(pages 4 - 6).
O Always wear eye protector which conforms to ANSl
Z87. I specifications.
e Never point Nailer toward yourself or anyone else.
O Never carry with finger on trigger.
Remove finger from trigger when not driving nails.
O Never place your hands or feet closer than 8 inches
(200 mm) from firing head when using.
O Do not drive nails on top of other nails or with
Nailer at too steep of an angle; nails can ricochet
and hurt someone.
O En order to avoid double fire or unwanted ejection
of a naii due to bouncing of the Nailer.
1) do not push Nailer on workpiece with strong
fo ree ;
2) take Naiier away from workpiece using recoil;
3) release trigger quickly when performing trigger
fire.
O Do not drive nails into thin boards or near corners
and edges of workpiece. Naile can be driven
through or away from workpiece and hit someone.
O Never drive nails from both sides of a walt at the
same time. Nails can be driven into and through the
waN and hit a person on the opposite side.
O Never use Naiter which is defective or operating
abnormally.
O Do not use Nailer as hammer.
O Disconnect air hose from Nailer when:
1) it is not in use;
2) Ieaving work area;
3) moving it to another location; and
4) handing it to another person.
This Hitachi nailer has a STANDARD CONTACT TRIP
MECHANISM (Bounce Fire). An OPTIONAL SEQUENTIAL
TRIP MECHANISM kit (SINGLE SHOT) is available as order
part number 876762.
THE STANDARD CONTACT TRIP MECHANISM (Bounce
The Nailer is now ready to operate.
Fire) is for use where rapid fastener placement is desired and
must be operated in accordance with the fol]owing "Methods
of Operation".
-12-