Frigidaire FGDS3065PF_UC Use & Care Manual page 43

Removing and Replacing the Oven Door
CAUTION
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
To remove oven door:
1. Open oven door completely horizontal with floor (See
Figure 47).
2. Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (See
flat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 49).
4. Close the door to approximately 10 degrees from the
oven door frame.
5. Lift the oven door hinge arms over the roller pins
located on each side of the oven frame (See
To replace oven door:
1. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle (See
Figure 49).
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame (See
Figure 49 and Figure
must be fully seated onto the roller pins.
3. Fully open the oven door, horizontal with floor See
Figure 47).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the
locked position (See
5. Close the oven door.
IMPORTANT
Special door care instructions - Most oven doors contain
glass that can break. Do not close the oven door until all
the oven racks are fully in place. Do not hit the glass with
pots, pans, or any other object. Scratching, hitting, jarring,
or stressing the glass may weaken its structure causing
an increased risk of breakage at a later time.
Figure 48). A tool such as a small
50). The hook of the hinge arms
Figure 48).
Figure 47: Door hinge location
Figure 49).
Figure 48: Door hinge locks
Figure 49: Holding door for removal
roller
hinge
arm
Figure 50: Replacement and location of hinge arm and
roller pin
CARE AND CLEANING
Oven door
hinge
locations
about
10°
oven
door
hinge
pin
43