Frigidaire FGDS3065PF_UC Use & Care Manual page 18

BEFORE SETTING OVEN CONTROLS
door connector
bracket
Figure 19: Connector arm/door connection
5. While holding the connector arm in place, twist the
connector arm so the ends of the connector arm point
upwards (See Figure
now be locked into position.
6. Repeat steps 4 and 5 for the other connector arm.
End should
point up, as
explained
in Step 5
Figure 20: Left & right brackets, pointing up
7. Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out of
the oven freely when the door is opened or closed.
Figure 21)
18
20). The connector arm should
End should
point up, as
explained
in Step 5
connector
arm
with connector arm ends
shown in locked position
Figure 21: Effortless™ oven rack after assembly
CAUTION
Remove all oven racks and accessories before starting a
self-clean cycle.
If the oven racks are left in the oven during the self-clean
cycle, the gliding ability of the Effortless™ Oven Rack
system will be damaged, and oven racks will lose their
shiny finish and may turn blue.
Remove all oven racks and clean according to instruc-
tions provided in the Care & Cleaning section of this
manual.
Make sure the oven and oven racks are completely cool
when trying to assemble or disassemble the Effortless™
Oven Rack system.
Never pick up hot oven racks or parts.
(See
left and right
door connector
brackets
(pointing upwards)
connector
arm