IKEA VARDESATTA Instruction page 9

2. Lift the pressure regulator 3 up and out.
3. Rinse the pressure regulator with hot
water. Note! You can also use a small
amount of mild detergent and a very
soft brush if necessary.
4. Clean the lid (see section below).
5. Re-insert the pressure regulator into the
lid.
6. Tighten the union nut for the pressure
regulator 3 by screwing it in a clockwise
direction. Use the key 10 supplied for
this purpose.
Note! If steam is escaping from the safety
opening 2 after the pressure regulator 3 has
been fitted, check:
— Whether the union nut for the pressure
regulator 3 is properly tightened – the
union nut should be tightened firmly by
hand using the key 10.
— Whether the three protective caps in the
pressure regulator are defective or not
properly fitted – unscrew the pressure
regulator and check the fit and integrity
of the protective caps.
— If none of the above measures success-
fully remedies the malfunction, please
contact your nearest IKEA store/Cus-
tomer service or see www.ikea.com for
support.
How to clean the safety valve (5)
1. Unscrew the fastening bolt for the safety
valve 5 by turning it in an anticlockwise
direction. Use the key 10 supplied for
this purpose.
2. Lift the safety valve 5 up and out.
3. Rinse the safety valve with hot water.
Note! You can also use a small amount
of mild detergent and a very soft brush
if necessary.
4. Clean the lid (see section below).
5. Re-insert the safety valve into the lid.
6. Tighten the fastening bolt for the safety
valve 5 by screwing it in a clockwise di-
rection. Use the key 10 supplied for this
purpose.
9