Error Codes - LG WT5480C series Owner's Manual

TROUBLESHOOTING 35
ERROR CODES
The display shows:
The display shows:
The display shows:
The lid is not closed properly
Lid lock switch error,
Make sure that the Jidis closed properly
and press the START!PAUSE button. After
starting a cycie, it may take a few moments
before the tub begins to turn or spin The
washer will not spin unless the lid is locked
If the lid is closed and the Iid lock error mes-
sage is displayed, call for service
Make sure that the tid is dosed properly and
press the START!PAUSE button The washer
will not operate unless the lid is locke&
Make sure that nothing is caught under the
_id, including shipping materia_ or c!othing,
Make sure that the latch mechanism is ful}y
retracted.
if the lid is closed and the tid lock error rues-
............. sage iS displayed, call for se[vice_
Speciai Drain Feature, if the washer is paused durfng a cycle for
Water supply faucets are not fully
open
Water line hoses are kinked,
3inched, or crushed,
Water iniet fiiters are clogged,
Water supply pressure to faucet or
house is too low.
Water supply connected with leak
limiting hoses,
Power cord is not properly
plugged in.
House fuse Jsblown, circuit break-
er has tripped, or power outage
has occurred
Washer fills with water slowiy or
not at all, or the display shows:
Washer will not turn on
more than five minutes, the cycJe wi_Jbe
cancelled and any water remaining in the tub
will be drained
Make sure that the water faucets are fully
open,
Make sure that the hoses are not kinked or
pinched. Be carefuJ when moving the washer
during cJeaning and maintenance,
Ciean the iniet filters. See Maintenance in
the Care and Cleaning section,
Check another faucet in the house to make
sure that househo!d water pressure is ad-
equate and ftow is not restricted. Disconnect
the inlet hose from the washer and run a few
galions of water through the hose to flush
the water supply lines. If flow is too Jew,
contact e plumber to have the water lines
repaired,
Hoses designed to limit teaks can trip falsely
and prevent the 'washer from fiJiing, The use
of bakdimitin9, hoses is not recommended
Make sure that the plug is plugged securely
into a grounded, 3_prong. 120 VAC, 60_Hz.
outbt
Reset circuit breaker or repbce fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a quaSi-
fled electrician.