Position Discharge Chute; Operate Unit - Ariens 938030-SS21 Operator's Manual

8. Electric Start Models Only: When engine
starts, disconnect power cord from wall
outlet, then disconnect cord from power
cord receptacle.
9. Recoil Start: Pull recoil starter handle.
a. Grasp handle and pull rope out slowly
until it pulls harder.
b. Pull handle firmly and quickly with a
rapid, continuous full-arm stroke.
Repeat until engine starts. If engine
does not start, see Troubleshooting
on page 18.
c. Let handle rewind slowly after engine
starts. DO NOT let handle snap back
against handlebar.
10. Gradually open choke after engine starts.

POSITION DISCHARGE CHUTE

See Figure 8.
IMPORTANT: Always throw snow in a safe
direction, away from people and windows.
IMPORTANT: If chute becomes frozen and
does not turn correctly, take unit into warm
area until controls are unfrozen.
Model 938033:
1. Move remote discharge chute handle
forward or backward to choose the
direction to throw snow.
2. Loosen wing knob and move discharge
chute deflector handle up or down to
control snow throw height.
3. Tighten wing knob.
Models 938030, 938031, 938032, 938034:
1. Turn discharge chute handle in the
direction you want to throw snow.
2. Loosen wing knob and move discharge
chute deflector handle up or down to
control snow throw height.
3. Tighten wing knob.
1
1. Discharge Chute Handle
2. Wing Knob
3. Discharge Chute Deflector Handle

OPERATE UNIT

1. Rotate discharge chute and move
deflector to desired positions.
NOTICE: On some surfaces, auger paddle
rotation may leave residual paddle material.
This usually washes off after rain showers.
Scraper bar may be adjusted to minimize this
condition. See Adjust Scraper Blade on
page 15.
2. Pull auger control bar back to handlebar
to start auger; release bar to stop auger.
See Figure 9.
EN - 11
3
Figure 8
2