Settings - IKEA SKINANDE Manual

ENGLISH

Settings

Programme selection mode and user
mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings can
be changed:
• The activation or the deactivation of the
acoustic signal for end of programme.
• The deactivation of the rinse aid
dispenser when you want to use the
Multitab option without rinse aid.
These settings will be saved until you
change them again.
How to set the programme selection mode
The appliance is in programme selection
mode when the programme indicator
is on and the display shows the
programme duration.
When you activate the appliance, usually it
is in programme selection mode. However,
if this does not happen, you can set the
programme selection mode in the following
way:
Press and hold simultaneously
and until the appliance is in programme
selection mode.
Use of rinse aid and multi-tablets
When you activate the option Multitab, the
rinse aid dispenser continues to release
rinse aid. However you can deactivate the
rinse aid dispenser. In this case the drying
results may not be satisfactory.
With the rinse aid dispenser deactivated,
the rinse aid indicator is always off.
How to deactivate the rinse aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
start to flash and the display is blank.
2. Press .
• The indicators
off.
• The indicator
• The display shows the current setting.
– = rinse aid dispenser
activated.
– = rinse aid dispenser
deactivated.
3. Press to change the setting.
4. Press the on/off button to confirm the
setting.
Acoustic signals
The acoustic signals operate when the
appliance has a malfunction and it is not
possible to deactivate them.
There is also an acoustic signal that
operates when the programme is
completed. By default, this acoustic signal is
on, but it is possible to deactivate it.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and hold
simultaneously
the indicators
start to flash and the display is blank.
2. Press
and until
, and
and
continues to flash.
and until
, and
.
10
go