Table of Contents
Advertisement
T-300
Air Curtain Trench Burner with Perkins 404D.22T or Kubota V2403-TE Engine
HOW TO PREPARE THE MACHINE FOR TRANSPORT
1.
Before working on the machine to prepare for transport the fire must be complete-
ly extinguished.
2.
Leave the manifolds extended, raise the rear jacks to lift the manifold from the
ground.
3.
Remove the bolt securing the manifolds and fold them back using the handles.
The manifolds should be locked into position by lifting slightly into the storage
hooks on the carrier pipe.
4.
Winch the carrier pipe into the trailer. (see Page 11 for "winch operation"). Never
push the carrier pipe with a vehicle, such as a front loader.
5.
NOTE: THE FRONT END OF THE TRAILER SHOULD BE SLIGHTLY LOWER
THAN THE BACK; USE JACK STANDS TO ADJUST. THIS WILL MAKE IT EASI-
ER TO PUSH THE CARRIER PIPE BACK INTO THE MACHINE. IF THE TRAIL-
ER FRONT IS HIGHER THAN THE BACK ,THEN IT MAY CAUSE THE CARRI-
ER PIPE ASSEMBLY TO SLIDE BACK OUT OF CONTROL, CAUSING DAM-
AGE OR INJURY.
6.
Fit the securing bolt at the front of the carrier pipe to lock the carrier pipe into posi-
tion. Always use both, nut and cotter pin.
7.
Attach the trailer to tow vehicle.
DANGER:
FAILURE TO PROPERLY FIT THIS SECURING BOLT MAY RE-
SULT IN THE CARRIER PIPE DEPLOYING WHILE THE TRAILER IS BEING
TOWED. THIS COULD CAUSE DAMAGE, SERIOUS INJURY OR EVEN DEATH.
8.
Remove the jacks and store them. Use the storage box inside the top cowling.
9
Close the cowling and make sure it is secure with all three latches secured and
center "D" lift latch locked.
10. Connect the trailer and vehicle electrics and ensure that all lights and brakes func-
tion correctly before entering the highway.
11. Connect safety chains and secure hitch with suitable pin or locking device before
DANGER:
CARE MUST BE TAKEN WHEN WORKING AROUND THE PIT.
THERE IS A RISK OF FALLING INTO THE PIT WHICH MAY RESULT IN SERI-
OUS INJURY OR EVEN DEATH.
Page 25 of 34
Air Burners, Inc.
OPERATING MANUAL
(Vers. 08.16)
Advertisement
Table of Contents
