Changing A Program; Opening The Door - Electrolux EWW12842 User Manual

20 www.electrolux.com
5.2 Interruption Of A Program
- To pause press Start/ Pause. The
indicator will start flashing.
- Press the Start/Pause again. The
program will continue.

5.3 Changing A Program

Changing a running program is possible
only by resetting it.
1. Turn the program selector knob to the
position "
and to turn off the appliance.
2. Turn the program selector knob to the
new program position and set the new
option, then press "Start/Pause"
touchpad again.
The appliance will not drain
the water.
5.4 Changing The Options
It is possible to change only some option
after the program has started.
1. Press the touchpad Start/Pause. The
indicator will start flashing.
2. Change the options.
3. Press Start/Pause again. The program
will continue.

5.5 Opening The Door

While a program or the 'Delay Start' is
operating, the appliance door is locked and
the display shows the indicator '
First set the machine to PAUSE by pressing
the "Start/Pause" touchpad. Wait until the
door lock indicator '
door can be opened.
If the door lock indicator '
disappear, this means that the machine is
already heating and the water level is above
the bottom edge of the door or the drum is
turning. In this case the door CAN NOT be
opened.
" to cancel the program
' goes off, then the
' does not
If you can not open the door but
you need to open it you have to
switch the machine off by turn the
program selector knob to the
position "
appliance. After about 5 minutes the
door can be opened.
5.6 At The End Of The Program
-
The appliance stops automatically.
-
The acoustic signal will operate.
-
The display will show '
-
The indicator of the touchpad
Start/Pause goes off.
-
The door lock indicator '
goes off.
-
Remove the laundry from the
appliance. Make sure that the
drum is empty.
- Keep the door ajar, to prevent the
mildew and odours.
-
Turn off the water tap.
At the end of the program the
time remaining can suddenly
decrease from 7 minutes or less
to 0 due to the overestimated
total program time during the
load sensing phase. In some
cases (with perfectly balanced
load) the program time can be
'.
shorter than the time estimated
after the load sensing phase is
completed. This is a normal
behavior of the machine and not
a cause for concern as it does
not compromise its performance.
" to deactivate the
CAUTION!
Pay attention to the water
level and water temperature.
'.
'