Installation Requirements; Tools And Parts; Alternative Parts - Maytag W10408696B Installation Instructions Manual

Tools and Parts

Gather required tools and parts before starting installation.
Tools needed:
Adjustable or open end
wrenches ⁄ " (13 mm) and
1
2
⁄ " (14 mm)
9
16
4" min
(102 mm)
Wood block
Pliers that open to 1 9 ⁄ "
16
(39.5 mm)
Parts supplied:
NOTE: All parts supplied for installation are in the washer
basket.
Beaded tie strap
Drain hose form and hose
clamp
Optional tools:
Flashlight
2

INSTALLATION REQUIREMENTS

Level
Ruler or measuring tape
Drain hose
Transport bolt hole
plugs (Quantity will vary,
depending on model.)
Bucket
Parts needed: (Not supplied with washer)
Inlet hoses (2) with
washers (4)
Alternative Inlet Hoses:
(may be required for some installations, not supplied
with washer)
8212656RP 10 ft (3.0 m) Inlet hose, Black EPDM (2 pack)
n
8212641RP 5 ft (1.5 m) Inlet hose, Black EPDM (2 pack)
n
8212546RP 4 ft (1.2 m) Inlet hose, Black EPDM (2 pack)
n
8212545RP 5 ft (1.5 m) Inlet hose, Red and Blue EPDM
n
(2 pack)
8212487RP 5 ft (1.5 m) Nylon braided inlet hose (2 pack)
n
8212638RP 6 ft (1.8 m) Nylon braided inlet hose, space
n
saving 90° elbow, hypro-blue steel couplings
(2 pack)
8212637RP 6 ft (1.8 m) Inlet hose, Black EPDM, space
n
saving 90° elbow, hypro-blue steel couplings
(2 pack)
Available Accessories:
An optional matching pedestal is available for your washer.
Please contact your retailer for ordering information, or see
the Assistance or Service page on the back of your Use and
Care Guide.

Alternative parts

(Not supplied with washer)
Your installation may require additional parts. To order, please
refer to toll-free numbers on the back page of your Use and
Care Guide.
If you have:
Laundry tub or
standpipe taller than
96" (2.4 m)
Overhead sewer
1" (25 mm) standpipe
Floor drain system
Drain hose too short
Water faucets beyond
reach of fill hoses
You will need:
Sump pump system
(if not already available)
Standard 20 gal. (76 L) 30" (762 mm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
2" (51 mm) diameter to 1" (25 mm)
diameter Standpipe Adapter
Part Number 3363920
Connect Kit Part Number 285835
Siphon Break Part Number 285834;
additional Drain Hose,
Part Number 8318155; and Connector
Kit, Part Number 285835
Extension Drain Hose
Part Number 285863
2 longer water fill hoses;
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008