Installing The Stand; Disconnecting The Stand - Samsung 7000 User Manual

Series 7
Hide thumbs Also See for 7000:
Table of Contents

Advertisement

Problem
Image is not stable and may
appear to vibrate when you have
a computer connected to the PC
input.
Image is not centered on the
screen.
The picture appears distorted in the
corner of the screen.
The 'Resets all settings to the
default values.' message appears.
N
This TFT LED panel uses a panel consisting of sub pixels (6 220 800) which require sophisticated technology to produce.
However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
¦

Installing the Stand

1. Attach your LED TV to the stand.
N
Two or more people should carry the TV.
N
Make sure to distinguish between the front and back of the stand when
attaching it.
N
To make sure the TV is installed on the stand at a proper level, do not apply
excess downward pressure to the upper left of right sides of the TV.
2. Fasten screws at position 1 and then fasten screws at position 2.
N
Stand the product up and fasten the screws. If you fasten the screws with the
LED TV placed down, it may lean to one side.
¦

Disconnecting the Stand

1. Remove screws from the back of the TV.
2. Separate the stand from the TV.
N
Two or more people should carry the TV.
3. Cover the bottom hole with the cover.
Possible Solution
If the setting is not correct, use your computer utility program to change the display
settings.
Your TV supports multiscan display functions within the following frequency domain:
- Horizontal frequency (KHz): 30~60
- Vertical frequency (Hz): 60~75
- PC Maximum refresh rate (at 60 Hz): 1920 x 1080
Adjust the horizontal and vertical position.
The screen position must be adjusted on the output source (i.e. STB) with a digital signal.
If Screen Fit is selected with some external devices, the picture may appear distorted in
the corner of the screen. This symptom is caused by the external devices, not TV.
This appears when you press and hold the EXIT button for a while. The product settings
are reset to the factory defaults.
English - 82
2
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7100

Table of Contents