Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like the diagram to the right, see 'Antennas with 300
Flat Twin Leads' below.
If your antenna has one lead that looks like the diagram to the right, see 'Antennas with 75
If you have two antennas, see 'Separate VHF and UHF Antennas'.
Antennas with 300
Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or 'rabbit ears') that has 300 twin
Àat leads, follow the directions below.
1. Place the wires from the twin leads under the screws on a 300-75
supplied). Use a screwdriver to tighten the screws.
2. Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennas with 75
Plug the antenna lead into the ANT IN terminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine
the two antenna signals before connecting the antennas to the TV. This procedure requires an
optional combiner-adaptor (available at most electronics shops).
1. Connect both antenna leads to the combiner.
2. Plug the combiner into the ANT IN terminal on the bottom of the rear panel.
English - 8