Installation; Removal; Mounting The Microphone (Cde-113Bt/Cde-114Bti Only) - Alpine CDE-114BTi Owner's Manual

Installation

CAUTION
When you install this unit in your car, do not remove the
detachable front panel.
If the detachable front panel is removed during installation, you
might press too hard and warp the metal plate that holds it in
place.
The main unit must be mounted within 35 degrees of the
horizontal plane, back to front.
Less than 35°
1
Remove the mounting sleeve from the main unit (Refer to
"Removal" on page 31). Slide the mounting sleeve into the
dashboard and fix it with the metal shackles.
Bracket
Mounting Sleeve
Dashboard
(Included)
Pressure Plates
* If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
2
When your vehicle has the Bracket, mount the long hex
bolt onto the rear panel of the CDE-111R/CDE-111RM/
CDE-112Ri/CDE-113BT/CDE-114BTi and put the Rubber
Cap on the hex bolt. If your vehicle does not have the
Mounting Support, reinforce the head unit with the metal
mounting strap (not supplied). Connect all the leads of the
CDE-111R/CDE-111RM/CDE-112Ri/CDE-113BT/
CDE-114BTi according to details described in the
CONNECTIONS section.
Metal Mounting Strap
Hex Nut (M5)
*
* For the screw
, provide a proper screw to the chassis installing
location.
3
Slide the CDE-111R/CDE-111RM/CDE-112Ri/CDE-113BT/
CDE-114BTi into the dashboard. When the unit is in place,
make sure the locking pins are fully seated in the down
position. This can be done by pressing firmly in on the unit
while pushing the locking pin down with a small
Downloaded from Caradio-Manual.com Manuals
Rubber Cap (Included)
Hex Bolt
(Included)
*
This unit
Screw
*
Bolt Stud
This unit
screwdriver. This ensures that the unit is properly locked
and will not accidentally come out from the dashboard.
Install the detachable front panel.

Removal

1
Remove the detachable front panel.
2
Use a small screwdriver (or similar tool) to push the
locking pins to the "up" position (see above drawing). As
each pin is unlocked, gently pull out on the unit to make
sure it does not re-lock before unlocking the second pin.
3
Pull the unit out, keeping it unlocked as you do so.
JAPANESE CAR
This unit
Mounting the Microphone (CDE-113BT/
CDE-114BTi only)
For the sake of safety, mount the microphone in the following location.
• In a stable and secure location.
• In a location that does not inhibit safely driving the vehicle.
• Mount the microphone in a location where the driver's voice can
easily be picked up.
Choose a location for the microphone that can easily pick up the drivers
voice. Requiring the driver to move towards the microphone for
audibility causes a distraction that could be dangerous.
Lock Pin
Front Frame
Screw (M5 × 8)
(Included)
Mounting Bracket
31
-EN