Presetting Stations Automatically; Tuning To Preset Stations; Rds; Setting Rds Reception Mode And Receiving Rds Stations - Alpine CDE-114BTi Owner's Manual

Presetting Stations Automatically

1
Press BANDTA repeatedly until the desired radio band is
displayed.
2
Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.

Tuning to Preset Stations

1
Select the band, and then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Note
• If the  indicator is illuminated, turn off the indicator by pressing
FUNC.SETUP, and then you can perform the operation.
8
Downloaded from Caradio-Manual.com Manuals
-EN

RDS

Rotary encoder
BAND/TA FUNC./SETUP
  /ENT 1/AF
/SOUND
* The illustrator is for CDE-114BTi.
Setting RDS Reception Mode and Receiving
RDS Stations
The RDS (Radio Data System) is a radio information system using the
57 kHz subcarrier of regular FM broadcast. The RDS allows you to
receive a variety of information such as traffic information, station
names, and to automatically re-tune to a stronger transmitter that is
broadcasting the same programme.
1
Press FUNC.SETUP so that the  indicator lights up.
2
Press 1AF to activate the RDS mode.
3
Press  or  to tune in the desired RDS station.
4
Press 1AF again to deactivate the RDS mode.
5
Press FUNC.SETUP to activate the normal mode.
The  indicator goes out.
Note
• Operate the unit while the  indicator lights up. If no operation is
performed for 10 seconds, the  indicator goes out.
The RDS digital data includes the following:
PI Programme Identification
PS Programme Service Name
AF List of Alternative Frequencies
TP Traffic Programme
TA Traffic Announcement
EON Enhanced Other Networks

Recalling Preset RDS Stations

1
Press FUNC.SETUP so that the  indicator lights up.
2
Press 1AF to activate the RDS mode.
3
Press FUNC.SETUP to activate the normal mode.
The  indicator goes out.
VIEW