Thread; Winding The Lower Thread On The Bobbin; Adjustmentof The Bobbin Winder - Consew 226R Operating Instructions Manual

6
WINDING THE LOWER THREAD ON THE BOBBIN
(Fig. 8)
1. Push a bobbin on the bobbin winder spindle@)as far as it will go.
2. Pass the thread from the thread stand downward through the eye(!) in the
tension bracket, then between and around the back of the tension diSC@.
3. Bring the thread forward toward the bobbin and wind from below in clock-
wise direction several times around the bobbin.
4. Push the lever(!)toward the other side so that the pulleyand V belt (rJ),
Fig. 1)
will engage and then start the machine.
5. The pulley will automatically be free from the belt and stopped after the bob-
bin is filled with thread.
THE ABOVE OPERATION CAN BE DONE WHILE SEWING.
ADJUSTMENTOF THE BOBBIN
WINDER
1. IN CASE OF UNEVEN WINDING:
If the thread does not wind evenly ori the bobbin, loosen the screw<§) in the
tension bracket and move the bracket to the. right or to the left as may be
required, then tighten the screw(§).
2. WINDING AMOUNT OF THREAD:
Adjustment screw@ can be turned in or out to increase or to decrease the
amount of thread wound on the bobbin.
3. WINDING STRENGTH:
Strength of the winding can be adjusted with the nutrJ).
Fig. 8